Setting Fleck Econominder Program Wheel Gallons Position
How To Move Program Wheel To Set Gallons:
1 ) The "locking" teeth are under the part that says ( x100 ), so this is the critical area that must lift.
2 ) It is VERY HELPFUL ( maybe NECESSARY ) if you hold the Black Gear "down" while pulling up on the Clear portion.
3 ) Turn the Clear Portion counter clockwise, and Black Gear Clockwise
4 ) Line up "white" dot with the gallon setting you've computed.
How To Move Program Wheel To Set Gallons
1 ) The "locking" teeth are under the part that says ( x100 ), so this is the critical area that must lift.
2 ) It is VERY HELPFUL ( maybe NECESSARY ) if you hold the Black Gear "down" while pulling up on the Clear portion.
3 ) Turn the Clear Portion counter clockwise, and Black Gear Clockwise
4 ) Line up "white" dot with the gallon setting you've computed.
How To Move Program Wheel To Set Gallons
I had a difficult time finding any information about my 5600 Economider. I changed the settings for the worse and couldn't figure out exactly what everything meant. The manual was no help. I found this video linked from softenerparts.com and I was able to get my settings back to normal. Good information.
Reply to this
I just got my Fleck 5600 softener installed 2 months ago and noticed it doesn't regenerate. My investigation shows the white dot dial is rotating "clockwise" when I used water instead of going counter clockwise to zero as your video depicted. What is the problem and how can I resolve it. Thanks!
*** You have plumbed the water lines ( Inlet and Outlet ) BACKWARDS.
Reply to this